Attic Insulation
in Dripping Springs, TX
Attic insulation in Dripping Springs, TX. We measure the depth you actually have, photograph the bare spots and the gaps, and price removal and new blown-in separately, per square foot, in writing.
Why Dripping Springs Homes
Need a Attic Insulation
Hill Country houses are large, often with vaulted sections and multiple attic spaces that were never insulated to the same standard. The upstairs room that never cools is almost always sitting under the thinnest part.
We take depth readings across the whole floor rather than one by the hatch, so the map of where it is thin is a set of photographs with a tape in them, not an opinion.
In Dripping Springs that shows up across homes on acreage and custom-built residential properties alike.
Our Dripping Springs
Attic Insulation Process
Every visit starts with the free inspection. You see the photographs before you see a price, and the price is written down before anything is touched.
Note the bath and kitchen fans
A fan venting into the attic instead of outside puts moisture straight into the insulation. We photograph where each one actually terminates.
Measure what is there
Depth readings across the attic, not one reading by the hatch. Settled blown-in, bare joists and wet patches all get photographed with the tape in the shot.
Find where the heat is leaking
Ceiling penetrations, can lights, the attic hatch and the top plates. Insulation over an unsealed hole does very little, and we show you which holes yours has.
Decide removal honestly
Old insulation comes out when it is contaminated, wet or hiding damage. Where it is simply thin, topping it up is cheaper and we say so.
Protect the path in
Sheets from the door to the hatch and a sealed vacuum for removal. Nothing that comes out of the attic travels through the house loose.
Seal, then blow
Penetrations sealed first, then blown-in to a full measured depth, with baffles kept clear at the eaves so the roof still breathes.
What a Attic Insulation
Costs in Dripping Springs
Measured and quoted per square foot
Removal and new blown-in are separate lines and both are per square foot of attic, measured on the free inspection. We write down the depth we found and the depth we are proposing, so the number is arithmetic rather than a guess.
The inspection is free and there is no call-out fee. If the honest answer is that nothing needs doing, you get that in writing and pay nothing.
Your Local
Dripping Springs Team
Ready to book in Dripping Springs? +1 (737) 299 19 19 or book the free inspection.
Air Duct Busters is a family-run crew working out of Marble Falls since 2018, with a second base in Bertram. We work in Dripping Springs regularly, and more than 870 across Central Texas since we started. The owner, Gary Abdullaev, is a CSIA certified chimney sweep and an HVAC technician, and he is on the trucks, not just on the paperwork.
We come down US-281 south to Johnson City and take US-290 east into Dripping Springs, roughly 55 miles and an hour. Every Dripping Springs visit starts the same way: we open the system, photograph what is actually in it and hand you a written price per line before anything is touched. If the honest answer is that it does not need cleaning, you get that in writing and pay nothing.
Rated 4.9 by 71 Google reviews
From homeowners across the Highland Lakes and the Austin suburbs, not bought and not filtered.
One crew for the whole house
Ducts, dryer vents, chimneys and attic insulation are the same visit and the same written quote.
Photographs before the price
Every line on the quote points at something we photographed in your house.
The line is answered around the clock
Call +1 (737) 299 19 19 at any hour, seven days a week, and we book the window that suits you.
What We Find in
Dripping Springs Homes
Six things the crew photographs most often on Dripping Springs inspections. If one of them sounds like your house, the inspection is free and the fix is priced in writing.
Thin or Uneven Attic Insulation
Bare spots, settled blown-in and unsealed can lights are the reason upstairs rooms never cool. We measure the depth on every attic visit.
Lint Packed in the Dryer Vent
Clothes take two cycles, the top of the dryer runs hot and the outside flap barely opens. That run gets cleared from the dryer to the cap.
Disconnected or Crushed Attic Ducts
A supply line blowing into the attic or a flattened flex run behind the water heater. Found on the inspection, sealed or replaced on the spot.
Creosote and Cracked Flue Tiles
A fireplace that smokes back or has not been swept in years. We sweep, inspect and photograph the flue before the first cold front.
Dust That Comes Back a Week After Cleaning
Grey fuzz on the registers and the furniture again. The supply lines and the return plenum are holding what the filter never caught.
Unsealed Can Lights and Ceiling Penetrations
Every unsealed fixture is a hole between the house and the attic. We seal them while the insulation is open rather than blowing over the top of them.
Attic Insulation Before
& After
Photos by our crew on the job. Nothing staged.
BeforeAfter
BeforeAfter
BeforeAfter
BeforeAfterLocal Rules and Paperwork
in Dripping Springs
Things Dripping Springs homeowners ask about that have nothing to do with the work itself, and everything to do with selling, insuring or getting an association form approved.
Selling in Hays County
The TREC inspection report has its own lines for the fireplace, the flue and the dryer exhaust. On a house with a wood-burning fireplace that gets used, a pre-listing sweep with photos is the cheapest item on the list to clear.
Propane gas logs
Outside the gas mains most fireplaces here run on propane from a yard tank. Those need the same annual look as natural gas, and the parts the inspection covers are the flue, the screen, the burner and the pilot assembly, not the log set.
Wells, septic and rainwater collection
None of that touches the ducts, but it does mean the house has systems a general inspector will flag. We stay in our lane, photograph what we find in the air path and say plainly when something is outside our work.
HOA approval in Belterra, Headwaters and Caliterra
Anything visible from the street, a new cap or a vent hood included, goes through architectural review first. We hand you the spec and a photo for the form.
Getting to Dripping Springs
From Marble Falls
We come down US-281 south to Johnson City and take US-290 east into Dripping Springs, roughly 55 miles and an hour. Johnson City, Blanco and Wimberley sit on the same run, so a Dripping Springs booking often shares a day with one of them, and the crew carries the extra hose length for acreage properties as a matter of course.
More about what we do in this town on the Dripping Springs page, or read the full attic insulation service page.
Book a Attic Insulation in Dripping Springs
We come out to Dripping Springs, look at what you actually have and photograph it. The inspection is free and the price is in writing before any work.
Attic Insulation in
Nearby Towns
The same crew in the towns around Dripping Springs.
What Else We Do
in Dripping Springs
Ducts, dryer vents, chimneys and attic insulation are one crew and one visit. Each has its own Dripping Springs page.
Attic Insulation in Dripping Springs
Questions
How deep should attic insulation be here?
Central Texas attics want a full blown-in depth across the whole floor, and most of the houses we open are well under it because the material has settled over the years. We measure yours and write the number down whether or not you buy anything.
Do I need to remove the old insulation?
Only if it is contaminated, wet or hiding damage. If it is simply thin, topping it up costs less and works nearly as well. We photograph what is up there and tell you which case yours is.
Will new insulation lower my summer bill?
It is the single biggest lever on a Central Texas summer bill, but only once the holes in the ceiling are sealed. Blowing over unsealed can lights buys much less than the brochure suggests, so we seal first.
Do you work around the ductwork?
Yes, and we leave it visible rather than burying it. Buried flex is how a crushed or disconnected run goes unnoticed for years.
How long does the work take?
A measured inspection is under an hour. Removal and new blown-in on a typical attic is most of a day, and we tell you which it is before booking rather than after.
Do you serve all of Dripping Springs?
Yes, the whole town and the country around it. We come down US-281 south to Johnson City and take US-290 east into Dripping Springs, roughly 55 miles and an hour. Johnson City, Blanco and Wimberley sit on the same run, so a Dripping Springs booking often shares a day with one of them, and the crew carries the extra hose length for acreage properties as a matter of course.
Can you do this on the same visit as the ducts?
Yes, and most people do. The same crew handles ducts, dryer vents, chimneys and attic insulation, so it is one trip to Dripping Springs and one written quote.